TagLine Here

Frame Sliders AFP-26



  • '02-'03 YZF1000 R-1

The frame sliders are mounted to the upper engine mounts. 
The fairings require modification during installation.  This is
best done by first removing the fairing.  Locate the engine mount
bolt & replace with the supplied bolt.  If heat shield foam is not
present, apply playdough to inside fairing where cutting will
take place.  Put the fairing back and see where the bolt head
has left an impression in playdough/heat foam.  This is the
center of the hole to be drilled.  Mask outside of fairing with
tape to prevent chipping during drilling.  Take 2" hole saw and
center around bolt head impression in playdough.  Drill through
fairing.  Lightly file down rough edges around hole.  Install short
slider and replace the fairings.  Only the right side needs

Includes: (2) Aluminum pucks
                  (1) 10mm x 1.25 x 60mm bolt (right side & short puck)
                  (1) 10mm x 1.25 x 70mm bolt (left side & long puck)

Add to Cart: