TagLine Here

Frame Sliders FP-125

$61.95

 

 

Honda

  • ’03-’06 CBR-600RR

The frame sliders are mounted to the top engine mounts.  
Both fairings require modification during installation. 

This is best done by first removing the fairing.  Locate

the engine mount bolt & replace with the supplied bolt.

If heat shield foam is not present, apply playdough to

inside fairing where cutting will take place.  Put the

fairing back and see where the bolt head has left an

impression in playdough/heat foam.  This is the center

of the hole to be drilled.  Mask outside of fairing with tape

to prevent chipping during drilling.  Take 2" hole saw and
center around bolt head impression in playdough.  Drill

through fairing.  Lightly file down rough edges around

hole.  Install slider and replace the fairings.  Start on

the left side, remove the motor mount bolt and replace

with the short bolt with the long slider.

Repeat this process on the right side using the short

slider, long  bolt with spacer and nut. 

Torque to factory specs.

 

Includes: (2) Acetal pucks with aluminum bushings

                  (1) 12mm x 1.25 x 130mm (right side and short puck)

                  (1) aluminum spacer and 12mm nylon locking nut

                  (1) 12mm x 1.25 x 100mm (left side and long puck)



Add to Cart:

Please Choose: