TagLine Here

Frame Sliders FP-30



  • 99-02YZF-600 R-6

The frame sliders are mounted to the upper engine mounts.
Both fairings require modification during installation. This

is best done by first removing the fairing. Locate the engine

mount bolt & replace with the supplied bolt. If heat shield foam

is not present, apply playdough to inside fairing where cutting

will take place. Put the fairing back and see where the bolt

head has left an impression in playdough/heat foam. This is

the center of the hole to be drilled. Mask outside of fairing with
tape to prevent chipping during drilling. Take 2" hole saw and
center around bolt head impression in playdough. Drill

through fairing. Lightly file down rough edges around hole.

Install slider and replace the fairings.


Includes: (2) Acetal pucks with aluminum bushings
(2) 12mm x 1.25x 90mm bolts

Add to Cart:

Please Choose: