TagLine Here

Frame Sliders FP-42

$61.95

 

 

Kawasaki

  • ’04-’05 ZX-10R


The frame sliders are to be mounted to your upper engine

mount bolts.  Refer to your service manual before

performing this installation. Both fairings require

modification during installation.  This is best done

by first removing the fairing.  Locate the engine

mount bolt & replace with the supplied bolt.  If heat

shield foam is not present, apply playdough to inside

fairing where cutting will take place.  Put the fairing

back and see where the bolt head has left an impression

in playdough/heat foam. This is the center of the hole to

be drilled.  Mask outside of fairing with tape to prevent

chipping during drilling.  Take 2" hole saw and center

around bolt head impression in playdough. Drill through

fairing.  Lightly file down rough edges around hole. 

Install slider and replace the fairings.  Simply remove

your engine mount bolts and install sliders with bolts

supplied in the kit (10mm x 1.25 x 70mm). Both sides

are the same.   Always torque bolts to factory specifications.

 

Includes: (2) Acetal pucks with aluminum bushings (identical)

                  (2) 10mm x 1.25 x 70mm bolts


Add to Cart:

Please Choose: