TagLine Here

Frame Sliders FP-175

$61.95

 

 

Honda

  • 04-05CBR-1000RR


The frame sliders are mounted to the top engine mounts.
The fairings require modification during installation. This is
best done by first removing the fairing. Locate the engine

mount bolt & replace with the supplied bolt. If heat shield

foam is not present, apply playdough to inside fairing where

cutting will take place. Put the fairing back and see where

the bolt head has left an impression in playdough/heat foam.

This is the center of the hole to be drilled. Mask outside of

fairing with tape to prevent chipping during drilling. Take

2" hole saw and center around bolt head impression in

playdough. Drill through fairing. Lightly file down rough

edges around hole. Install slider and replace the fairings.

Start on the left side, remove the motor mount bolt and replace

with the short bolt with slider. Repeat this process

on the right side using the long bolt and slider. Torque to

factory specs.

 

Includes: (2) Acetal pucks with aluminum bushings (identical)

  (1) 12mm x 1.25 x 90mm (left side)

  (1) 12mm x 1.25 x 100mm (right side)


Add to Cart:

Please Choose:




Customers who bought this product also purchased...